Buy it Again
Race Pro Carb And Intake Cleaner - 10 Oz

Race Pro Carb And Intake Cleaner - 10 Oz

Carburetor and Choke Cleaner, Supreme

Removes carbon, gum and varnish deposits. No CFCs: Contains no CFCs which deplete the ozone layer. Helps restore carburetor performance by removing gum, varnish, carbon deposits and dirt build-up. Cleans and frees automatic chokes, carburetor linkage, fuel injection intake systems, manifold heat controls and PCV smog valve. Steel. Made in USA.
Product Attributes
Warning Contains: Danger: Extremely flammable. Vapor harmful. Harmful or fatal is swallowed. Skin and eye irritant. Contents under pressure. Read back panel carefully. Danger: Contains Acetone (CAS No. 67-64-1), Xylene (CAS No. 1330-20-7), 2-Butoxyethanol (CAS 111-76-2), Carbon Dioxide (Propellant) (CAS No. 124-38-9), and Phenylethane (CAS No. 100-41-4). Extremely flammable. Do not puncture or incinerate container. Do not expose to heat sources including sparks and open flames or store at temperatures above 120 degrees F. Use only in well ventilated area. Inhalation of vapors may be harmful or fatal. Avoid breathing vapors. If overcome by vapor, move to fresh air. Eye and skin irritant. Avoid contact with eyes or prolonged skin contact. If contact or skin irritation occurs, flush area with large amounts of water for 15 minutes. If medical symptoms or irritation persists, seek medical attention. Harmful or
Directions Automatic Chokes - Remove air cleaner, disconnect heat riser tube, remove choke cover, but first mark position, take out baffle plate. Spray contents on the vacuum piston and cylinder and then on both ends of choke valve shaft. Keep working choke until it becomes free. Start engine and spray the piston and cylinder while working the choke by hand. Replace baffle plate, choke cover, heat riser tube and air cleaner. Carburetor Linkage - Spray on dirty or oily linkage. let set for a few seconds and flush off by spraying again. Fuel Injection Intake Systems - Dismantle and/or access fuel injection air and fuel intake systems. Spray liberally to instantly dissolve baked-on gum, carbon, soil and resin deposits. Manifold Heat Controls - Spray on exposed part of heater valve shaft while engine is cold. Let fluid penetrate. then move counterweight up and down until valve is free. PCV Smog Valve - Disconnect crankcase side of the PCV valve, leave vacuum side corrected. Apply by inserting snorkel
About the Producer Race Pro Products

Disclaimer

Product details/images for convenience only.  Consult Product label for the most current and accurate information.  We assume no liability for any inaccuracies/misstatements about Products listed on our website/app.